copy paste api commands

Submitted by eh on Sun, 04/08/2018 - 09:38
Forums: 
Journaling / NXOpen API

Hi

When the nxmanager open part dialog is open
I can right click a part and choose copy
and then in the same nxmanager opened dialog
I can brows to a folder and right click the
folder and choose paste, and the part-link
is copied in that folder.

Do someone can help in the nx api that
do the equivalent of this.

I'm thank you a lot.

NXJournaling - Mon, 04/09/2018 - 04:48

I'm fairly sure that this would have to be done through the Teamcenter API; I don't think it can be done with the NXOpen API.

eh - Mon, 04/09/2018 - 08:24

Thank you for respond me.

Is it possible to run Teamcenter API on nx manager mode.?
(run Teamcenter API in a nx journal)

Thank you again.

NXJournaling - Mon, 04/09/2018 - 08:50

I don't know enough about the teamcenter API to give a definitive answer. You might try asking your question in the Siemens community programming and customization forum:

https://community.plm.automation.siemens.com/t5/NX-Programming-Customiza...

eh - Mon, 04/09/2018 - 12:58

I'm very thank you.